There are often some problems with the roll paper of the paper slitting and rewinding machine, which plays an important role in the wide roll slitting and subsequent re-slitting. The paper slitting and rewinding machine is a special equipment for producing paper, mica tape and film. Then how do we generally solve the problem of paper slitting and rewinding machine?
The problems and solutions of the paper slitter rewinder machine are as follows:
It is always a waste of paper to start doing it now, how can we use it reasonably? Solution: How to make full use of paper and reduce waste. This requires you to pay more attention in normal times; you have to work hard when purchasing, and the width of the large paper roll you buy should be appropriate, so that there are fewer cuts on both sides. Secondly, when you are rewinding, try not to break the paper, do not produce unqualified products, and reduce waste.
The roll paper cut out by the paper cutter is always crooked, how can it be leveled? Solution: The paper roll cut by the paper cutter is always crooked. This should fix the parallelism between your jumbo roll and the drum of the separator rewinder, otherwise the paper would be skewed.
There is always a problem when it rains, is it related to wet paper? Solution: Toilet paper is absorbent. In rainy days, due to the relatively high air humidity, the dryness of the outer layer and the inner layer of a large roll may be different, resulting in paper deformation and strength changes, resulting in easy paper breaks and quantitative deviations when rolling the paper.
When rolling the paper, worry about the core on the right, it will always break a small piece. As a result, you can't always turn it out. Solution: If the right side is always broken, then check whether the tension on this side of the paper is greater than that on the left side, causing the paper to be pulled too tightly and break.
After the paper slitter rewinder machine has been used for a period of time, sometimes there will be problems with malfunctions and loud noises. Is there a mechanical problem? Then do you know what is the reason for the noise failure of the paper slitter rewinder machine?
The paper slitting and rewinding machine is noisy. First check whether the screw is loose, if it is loose, tighten the screw quickly;
Check whether the belt is severely worn, whether it is caused by the noise caused by the loose belt;
Check whether the internal gear has noise caused by severe wear of the gear.
The transmission device of the paper separating and rewinding machine, such as the gear chain, needs to be greased after a period of use.
Pay attention to the stable voltage of the paper separating and rewinding machine, otherwise it is easy to burn out the motor; be careful not to let debris fall between the steel roller and the wool roller.
